Evap Fresh Coil Cleaner - 18oz

• Mildewstat (on hard inanimate surfaces)
• Fungicide (against pathogenic fungi)
• Works upside down for hard to reach areas
• Deodorizer
• Lemon scent
• EPA registered

This product is not for use on critical and semi critical medical device surfaces. This product is designed for cleaning, deodorizing, and disinfecting for hospitals, nursing homes, schools, hotels, homes, and food processing establishments. This product is effective where housekeeping is of prime importance in controlling cross-contamination from treated surfaces. EPA registered.
COOLING COILS DISINFECTANT CLEANER: This product is a disinfectant cleaner for small air conditioner cooling coils and refrigeration equipment, refrigerator, or freezer evaporative coils. When using this product to disinfect and clean cooling coils or evaporative coils, disconnect power to the unit before applying product.
It is a violation of Federal Law to use this product in a manner inconsistent with its labeling.
COOLING COILS DISINFECTANT CLEANER: This product is a disinfectant cleaner for small air conditioner cooling coils and refrigeration equipment, refrigerator, or freezer evaporative coils. When using this product to disinfect and clean cooling coils or evaporative coils, disconnect power to the unit before applying product. Follow the directions under the DISINFECTION, DEODORIZATION AND CLEANING section.
DISINFECTION, DEODORIZATION AND CLEANING: Shake can before using. Hold container six to eight inches from surface to be treated. Spray area until it is covered with white foam. Allow foam to penetrate and remain wet for 10 minutes. No scrubbing is necessary. Wipe off with a clean cloth, mop or sponge. This product will not leave grit or soap scum. Surfaces which may contact food must be rinsed thoroughly with potable water after use. For heavily soiled areas, a pre-cleaning step is required before treatment. When used in food processing establishments, cover or remove all food and packaging materials, remove all gross soils, saturate all surfaces with the spray product, scrub to loosen all soils, allow to soak for 10 minutes, thoroughly rinse all wetted and cleaned surfaces with potable water.
MILDEWSTAT: To control mold and mildew on pre-cleaned, hard, non-porous surfaces, spray surface to be treated making sure to wet completely. Let air dry. Repeat application at weekly intervals or when mildew growth appears.
BACTERICIDAL ACTIVITY: When used as directed, this product exhibits effective disinfectant activity against the organisms: Staphylococcus aureus, Salmonella enterica and Pseudomonas aeruginosa and meets AOAC Germicidal Spray Products Test requirements for hospital disinfectants.
FUNGICIDAL ACTIVITY: This product is fungicidal against the pathogenic fungi, Trichophyton mentagrophytes, when used as directed on hard surfaces found in bathrooms, shower stalls, locker rooms, or other clean, nonporous, hard surfaces commonly contacted by bare feet.